This is a design circuit for drive a motor. Using this circuit, you can drive a unipolar stepper motor. It operates in full step mode. You can get a stepper motor from an old 5.25 disk drive. The AVR attiny2313 micro controller controls the pulses for the stepper motor. This is the figure of the circuit.
The pulses are amplified by the ULN2003 driver. The driver accepts 5V inputs, the output for the driver is up to 30V so you can connect an stepper motor of up to 30V. With the two push switches you can drive the stepper motor CW or CC. The hardware consist of the AT2313 microcontroller which drives the ULN2003 driver and two push buttons to control the direction. The program code is made with the AVR BASCOM compiler.
